Locate the fluxgate compass on a suitable vertical surface. Drill four pilot holes and attach the fluxgate compass using the self- 3. Make sure that the fluxgate is positioned at least 0.8m (2ft 6in) away Note: If any doubt exists over magnetic suitability of the chosen site, the position may be surveyed using a simple hand bearing compass. The second instance is a possible problem with the compass or the compass wiring. You should try to 'box' the compass to see if there is an obvious problem. To 'box' the compass put the pilot in STANDBY, next swing the vessel a full 360 degrees.

• SmartPilot Series Commissioning Guide Document reference: 81273-1 Date: Date: December 2005. • Autohelm, HSB (High Speed Bus), SailPilot, SeaTalk and SportPilot are registered trademarks of Raymarine Ltd.

Check gun serial numbers texas. Raymarine, SmartPilot, AST (Advanced Steering Technology), AutoAdapt, AutoLearn, AutoRelease, AutoSeastate, AutoTack, AutoTrim, FastTrim, GyroPlus, RayGyro, RayPilot and WindTrim are trademarks of Raymarine Ltd © Handbook contents copyright Raymarine plc. • This handbook contains important information about the installation and commis- Note: sioning of your new Raymarine product. At the back there is an index and glossary of terms.

To get the best from the product please read this handbook thoroughly. • As correct performance of the boat’s steering is critical for safety, we STRONGLY RECOMMEND that an Authorized Raymarine Service Representative fits this product. You will only receive full warranty benefits if you can show that an Authorized Raymarine Service Representative has installed or commissioned this product. • EMC Guidelines All Raymarine equipment and accessories are designed to the best industry standards for use in the recreational marine environment. Their design and manufacture conforms to the appropriate Electromagnetic Compatibility (EMC) standards, but correct installation is required to ensure that performance is not compromised. • Raymarine equipment.

Always use the ferrites supplied by Raymarine. Connections to other equipment If your Raymarine equipment is to be connected to other equipment using a cable not supplied by Raymarine, a suppression ferrite MUST always be attached to the cable near to the Raymarine unit.

• Contents Important Information. I About the documentation provided. I WARNING: Product installation. Ii WARNING: Electrical safety.

Ii WARNING: Calibration requirement. Ii WARNING: Navigation aid. Ii EMC Guidelines. Iii EMC suppression ferrites.iv Connections to other equipment.iv Handbook information. • Off switch (S2 and S3 only).15 Connecting spool valves (S2 and S3 only). 15 Selecting clutch voltage (S3 & S3G only). 16 1.10Secure the cables.17 S1 systems.17 S2 and S3 systems.17 Chapter 2: SmartPilot Commissioning.19 WARNING: Calibration requirement.19 SmartPilot Controller Compatibility.19 2.1 Dockside Checks.19 WARNING.